vince159 Posted February 14, 2019 Report Share Posted February 14, 2019 Hello Folks, I have my first DNA 250 that I've built into a mod, and I've been unable to make any changes to it's settings using Escribe. With my DNA 200's I've been setting up what I want with temp control, wattage settings etc, hit up load settings, and it all configures onto the mod; with the 250 it will not do this. I've been trying to figure this out for some time now. Any suggestions? Thanks very much. Link to comment Share on other sites More sharing options...
dwcraig1 Posted February 14, 2019 Report Share Posted February 14, 2019 Are you using a version of EScribe that is one of the older versions that came out before the 250? Link to comment Share on other sites More sharing options...
vince159 Posted February 14, 2019 Author Report Share Posted February 14, 2019 Hi Craig, long time no see. Yes, in fact, I am. I wasn't informed, didn't get a letter, post card or email I'll look into it; Thanks very much Sir. Link to comment Share on other sites More sharing options...
dwcraig1 Posted February 14, 2019 Report Share Posted February 14, 2019 40 minutes ago, vince159 said: Hi Craig, long time no see. Yes, in fact, I am. I wasn't informed, didn't get a letter, post card or email I'll look into it; Thanks very much Sir. https://forum.evolvapor.com/topic/66731-early-firmware-and-escribe-suite/?do=findComment&comment=929633 Suggest Int. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now