West84 Posted September 16, 2015 Author Report Posted September 16, 2015 Couple of times during the day happens that I got a dead screen. During the dead screen,dna is firing normally. After approximately 20 seconds, it shows evolv dna 200 welcome screen just like I've powered it for first time. It's not a ribbon cable... Any idea?
Brandon Posted September 16, 2015 Report Posted September 16, 2015 attach the mod to the PC->Go to EScribe->click Help->About->Click the Evolv logo 7 times->open Device Monitor->on the left side of the screen next to Screen Disconnects, what does it say?
Gm111 Posted September 20, 2015 Report Posted September 20, 2015 Mines been doing this, I noticed that the fire button was touching the ribbon cable slightly when pressed, not squashing it inbetween the tactile switch but the screen would go blank without the tactile switch clicking (just slight pressure).
Brandon Posted September 22, 2015 Report Posted September 22, 2015 Keep it connected and Device Monitor up while vaping. When the screen disappears again, check to see if the 0 changes to a 1?
West84 Posted September 22, 2015 Author Report Posted September 22, 2015 That's gonna be hard,but I will try to do that. There is no rule when it's going to happen. But thank you!
addappt Posted October 2, 2015 Report Posted October 2, 2015 Brandon said:Keep it connected and Device Monitor up while vaping. When the screen disappears again, check to see if the 0 changes to a 1?What about it if it reads 83622 and keeps going up in the thousands?
scoopy Posted October 2, 2015 Report Posted October 2, 2015 That means basically it's not connected at all or hast been recognising it at all since it was powered up
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now