3x 18650 wiring diagram

[Badazz Vapor]

hey DNAers

I'm building a box with 3 18650 battery's. I can't seem to find a proper wiring diagram of that.
I guess it's not that difficult but i don't want to make a mistake.
can someone hook me up with that.
I don't want to take my wismec apart to check.

thnx

[dwcraig1]

https://forum.evolvapor.com/topic/67734-topic/?do=findComment&comment=909654
It's going to be the same whether Lipo or IMR, perhaps your looking for the diagram to jumper the balance plug though.

[Badazz Vapor]

That diagram is actually helpfull thanks.

The trouble is i have to figure out a proper batterie Lid for the mod and I planned the Batteries in series but have to figure out were to connect wich balancer wire.  
 

[dwcraig1]

https://forum.evolvapor.com/topic/67734-topic/?do=findComment&comment=909694

[Guest]

I hard wire all my batteries (18650 and packs) like this

[Badazz Vapor]

So it schould be like this and i need just two wires from the connector. 

BtW wich battery is actually the first or number 1

 

[Guest]

The one with the red wire going to it in your picture

[Badazz Vapor]

Oke, thnx. So i got to find a way to make the lower Battery Lid removeable with those Wires atached.

[Guest]

To make the wiring of the lid simple you could use a spring loaded contact pin for the balancing wire

[Badazz Vapor]

Oke that is possible. The original plan was to make the Lid out of damast steel like the
other applications on the Mod but i have to build the Bridge for two Batteries in to that lid as wel as
the negative pole and the balancer cable, without shorting the whole thing.