check battery therion 133

[ibaklawa]

hello kindly help as i am so upset i adjusted my dna200 to 19.24wh 2cell cutoff value 3v i have 4 sony vtc5 18650. i use each pair together and the problem in the 2 pairs. when i fire at 13% battery it not firing up to the requested wattage or give me check battery. kindly help.

[giz_60]

You are probably hitting the cell soft cutoff & the board is throttling back the wattage...try lowering the cell soft cut off to 2.75
What ohms is the coil you are trying to fire? Can you post a screen shot of device manager while firing?

[ibaklawa]

0.2ohm at 70w

[giz_60]

Also, the Wh you have are a bit high for those batteries & you probably have an incorrect .csv file for them as well...here is the .csv file for the VTC5's... Sony_VTC5 (2)_18650_2600 mah_15,785 Wh.csv  ...download this file, in the Mod tab, Load .CSV & select this file...set you Wh to 15.78 & then upload to device...

[ibaklawa]

i set the wh by using wh calculator. okay i will modify it. thanks alot.

[giz_60]

Any Wh calculator you use will usually give you a value that is higher than the actual Wh's...the .csv file & Wh value I gave you was obtained by running the battery analyzer on a Therion...

[ibaklawa]

what about cutoff value? should i modify it?

[giz_60]

Yes...2.75

[ibaklawa]

okay.. thanks alot

[giz_60]