Mawa000

It’s strange — I’ve followed the steps, the window closes after several clicks, but the fields are still not editable…🤷‍♂️

Ok, thank you very much. I’ll back everything up and try to keep the changes as specific and minimal as possible. In my opinion it’s tuned too tightly — we’re talking about a brand‑new POD with 40 or 50 puffs. I understand that resistance increases with use, but this feels excessively conservative.

I'm having exactly the same issue with a 0.8‑ohm POD, which the device reads as 1.2. In Escribe, under the Mod tab, the minimum and maximum resistance values appear, which the mod uses to determine what coil is installed. The problem is that these values are greyed out and I can’t modify them, only the “Fill Pod Min Power (with pressure, Replay)” field is editable. Is there any way to unlock the maximum resistance value so I can increase it slightly and make the mod correctly detect the POD?