Jump to content
Evolv DNA Forum

Ryan V

Members
 View Profile  See their activity

  • Posts

    8

  • Joined

  • Last visited

 Content Type 

Posts posted by Ryan V

  1. Temperature Control with Stainless Steel 316L

    in General Discussion

    Posted

    that picture is from last year😄. just joking...

    after that post, I tried with a single coil setup and everything went fine and the resistance changed whenever I was firing. But then, the "temp protect" error started appearing!

    everything was fine and the temperature-sensing material detected by the device and my setup was 0.4 ohm and 150c with 30wat power. but temperature protection didn't let me fire. even with a cooled atomizer and ohm remeasurement.

    Seriously, I've tried everything...

    I will put the statistics of my new atomizer soon💙

    • Like 1

  3. Temperature Control with Stainless Steel 316L

    in General Discussion

    Posted

    19 hours ago, CMK said:

    Hi, the message "temp protect" - only sporadically at that - sounds very much like a short circuit in the Atty in this context; or that you have contact with the housing of the Atty with the wire ends of your coil somewhere. What happens if you only use the deck alone (please wet the cotton well). Or, if you use a top coiler, without a top cap?

    I disassembled the atomizer and checked it carefully. sounds like the gold coating on the inner parts is disappearing (wearing out) sporadically and this is causing inconsistent ohm reading which is very important for TC mode.

    during atomizer analysis, I got multiple different ohms such as 0.381, 0.39, 0.41, and up and down again without even touching the coil or Atty!!

    fortunately, the inner parts are fully detachable, thus, Re-plating should be a good solution.

  5. Temperature Control with Stainless Steel 316L

    in General Discussion

    Posted

    maybe there is something wrong with my atomizer... I don't know really; also I tried a single coil and it worked! but now I'm getting a "temp protect" error every once in a while.

    it's still a question for me too...

    can I ask which DNA chipset you use? because I think there is something really wrong with 250c, though I can't tell for sure since I never had a DNA device before...

  6. Temperature Control with Stainless Steel 316L

    in General Discussion

    Posted

    It is definitely ss! I've been using this wire for a while...

    I tried something else. came out that it is good with one coil build! don't know why! Maybe there is something wrong with my atomizer...

    certainly, I don't have time to struggle with this vaping computer 😆 but I'll definitely come back for it!

    there is also something else that I think it's not related to this topic (if you know which topic it is, please comment the link for me)

    I've started to get temp protect once in a while, especially after I put down my device for a couple of minutes and try to use it next time.

  8. Temperature Control with Stainless Steel 316L

    in General Discussion

    Posted

    Hi everyone. I bought my device about a week ago and tried to use TC with SS 316L round coil, but it looks like the device is not recognizing the coil, and replay mode doesn't work either. I've tried to replace the coils and also tried new builds with different numbers of wraps! No matter what, replay mode doesn't work! 

    It is also worth mentioning that it worked for about a couple of minutes on my first try when I unboxed the device, and also for a couple of seconds on one of my attempts to try a new build and then went again!

    my coil wire: Vandy vape SS 316L round  26ga

    My build: 7wraps 2.5mm dual

     

     

×
×
  • Create New...