Peter onsea

Ok, I couldn’t screw the jorda in. The 510 isn’t spring loaded but has a reverse threaded screw. This sits in another screw wich seamed to have come out. I screwed it down a bit and now I have a reading of 0.68 Thanks for handing me the solution...

When I put the attie on any other mod, the ohms are correct(0.75) So the only thing I can check and clean(without opening the ultranude) is the 510. And that, I allready did....

As usual, it asks if I want to use my new coil with the 1,5 ohm setting. But even when I go to ‘atomiser’ and do the reading it also measures the coil to be.....1,47 now...

A month ago I bought an ultranude mod (evademods) I had problems with the DNA board from the start. It refused to fire saying temp protect. And I noticed a problem with my ohms. Today I put in a premade coil (0,65 ohm) and that’s what it said on my coilmaster. When I put it on my mod it measures 1,5 ohm. Is that why I’m having the temp protect issues? Does this happen a lot? My previous dna-boards measured the ohms each time I fired and adjusted the wattage accordingly. At least I can adjust the ohms to the correct vallue. Is there anything I can do about this? Thanks