Ramius

I'm in the same boat. Sadly, my ticket hasn't been responded to as of yet. The build on my Manta is 0.32 Ohms on my other mods, but is reading 0.34 on my Paranormal. Temp Protect message all of the time, sometimes in Watts mode. Locking in 0.30 seems to allow it to work temporarily, and I have even loaded a more accurate TCR curve for my SS316L, which has a slightly higher Ohms/meter than usual stainless. I have, however, just gave my firing pin a wiggle with a pen lid (at work, no small tools), and gotten underneath it to attempt to lift it a touch. Now my Ohms are reading 0.32... Just waiting to go and have a toot on it. I believe my issues started from a new RDA that I used, a Dead Rabbit, which I was struggling to take the top cap off and over-tightened it by accident. The RDA's 510 pin is slightly long, so I'm wondering if it has forced the pin down a bit too much.