Omega1397

Oh wow. So I should be using Ni200 for the material setting for my TC? Or should I use a special .csv? I really appreciate it! By the way, i'm talking about the Crown 3 coils here.

Hey thank you, I was referring to the crown 3, which is SS

Thanks. I found an .ecig profile for my therion and it works fine now!

Hey guys, I was trying to figure out how to use TC in my lost vapes paranormal and therion. What's strange is that now both my mods show 0 battery when they were already charged previously, and they can't run without being plugged into USB. The last thing I did was "restore default settings" in escribe, and then I made a TC profile with the "Uwell SS" CSV. If anyone could help me out it would be appreciated.

Woah wtf, both of my mods show 0 battery and give me a "check battery" error. The last thing I did was I restored my theme defaults, then I made a TC profile with the (Uwell Crown 3 SS) csv. When I try going into device manager I get the "Device is already in use" error

Hey guys, I've been having some issues using TC with my Crown 3 coils on my therion and paranormal 166. I'm trying a profile I found by searching on the forums, that has the preheat power at 100W, temp at 530 F, and power at 80 W. My issues are: On my .25 coil, my hits start hard, and then they get cool about 1.5 seconds in, and then I see the screen "Temperature protected", resulting in a short, unsatisfying vape. For my 0.5 Ohm coil, the same thing happens but I get the error "ohms too high". I was wondering if anyone could help me out. It would be very much appreciated!