-
Posts
7 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Posts posted by Toaster79
-
-
-
-
Just now, retird said:
You might have HCigar replace it...
It's the board, the wee little chip mentioned above. It happed the same moment I disconected the USB charger.
-
8 minutes ago, retird said:
What are the voltages for all 3 cells?
Cell1 0V
Cell2 5.02V
Cell3 3.98V
Pack 9V
-
1 minute ago, retird said:
What does it do in 3-cell config....
Same.
-
I'm on the same boat. Brand new Hcigar VT250S in 2 cell config. Cell 1 reads 0V, cell 2 reads 5.02V. Removing both cells, cell 2 still reads 2.26V. I've got 4 puffs on this device. I put 2 charged batteries in, the battery indicator shows empty batteries, so I plug my 1.5A USB charger in and after unplugging, the device won't come on again. Holding the fire buttun for long enough will show both initial screens and then "CHECK BATTERY"
HELP Hcigar 250VTS Check Battery error
in General Discussion
Posted
Did you by any chance remove the cover with the third battery while USB cable was attached and batteries installed?