Jesteir

Hello. I just got the tfv4 mini last week. Not sure which rba deck you are using but was having the same issue, not as drastic as you described, with Ti and the tfv4 deck. What I found is on the Clapton rba deck the chimney is tight tolerances. When I cut my coil after mounting the ends just touched after I fired the coil (yes with wet wick). I just push the ends tight to the screw heads and retighten the screws, which thought I was going to strip out the heads. Came out at .18 ohm twisted stable for 4 days use. Built single coil Ti last night .24 ohm with no issue. Wrapped the ends around screw heads before clipping to test my theory. Hope some of that helps with the previous posts.

That is the files that I am using. I did notice that the .5 and .4 files are different. Is there a reason for that? Used the steam file and running temp 460 for similar vape as sweet spot file.

If you are talking the csv file to Ti. Yes I did. other than that I do not see a way to do that. I did just download the steam engine Ti gr1 csv and tried and it acts like the more like the nickel did. looking at the csv files and monitor they hit different ohms for same temp. ssv one shows around .70 ohm at temp, SE file is around .60 ohm at temp. Could the files be that far off?

Okay guys new to the temp reg game. My question is I got a lavabox, using subtank mini's. I got a couple of Ni200 heads for it, one only lasted a tank or too before popping probably my fault, but both I had to run in high 400's to about 510. Got some ssv Ti 26g to build on rda. Love Ti taste to the Ni200, but running the temp at 320 to 350. 350 is almost to warm sometimes, but the Ni200 was still a cold vape at even 480. Anyone else seen these differences? Ni200 was .15 ohm, 3 different Ti builds, 2 on subtanks and 1 on freakshow. .38 ohm, other 2 around .26 ohm.