Jump to content
Evolv DNA Forum

Majnu

Members
 View Profile  See their activity

  • Posts

    10

  • Joined

  • Last visited

    Never

 Content Type 

Posts posted by Majnu

  1. Wismec DNA200 "Check Battery Fault"

    in General Discussion

    Posted

    Got a refund finally. Are there any guides on how to open it up as I would like to have a go at fixing it? I can see 6 screws at the battery sled area which removes the front surround around the screen and 2 small star screws at the bottom and top of the battery sled but then how do I proceed from there?

    Thanks

    edit - okay I remove the foam and the negative terminal screw and the sled slides out, but I guess needs desoldering to come away. 

  5. Wismec DNA200 "Check Battery Fault"

    in General Discussion

    Posted

    VapingBad said:

    Assuming the batteries are charges and you have cleaned the contacts (mod and battery) with IPA, rubbing alcohol, meths or other contact cleaner:

    Have a look in EScribe - Device Monitor for the cell voltages, if they are fully charged they should be 4.2 V also look for a low one, you can try and get them setted better in the battery tray if they are low.  If you have a low cell1 and can't solve it by swapping the batteries around, there is a screw hold blocked off with white foam behind the batteries, below that is a screw for the ground connection that might have loosened, but be careful not to over-tighten it. 

    If you change the batteries while connected to USB it may not have registered the power off so a soft reboot or removing and replacing the batteries may help.



    Just cleaned everything with IPA and connected to Escribe. The batteries are definitely fully charged. I have 2 sets of Samsung 30Q's fresh of charge. I use the XTAR VC4. 

    In Escribe it doesn't show 4.2. Infact it will be easier to take a screenshot.

  10. Proper use of Battery analyzer

    in Batteries and Charging

    Posted

    Have I run my batt analyzer correctly?

    I was told to use 2X 1.5 feet of 24 guage kanthal to make two loops. This gave me a resistance of 1.6 ohms. I ran the test at 50W

    However I wanted to see if anyone made a video on this and the only one I could find was in French, but I did see that his loop was glowing and whilst mine was running they were not. His shows at 40Watts 1.04ohms

    https://www.youtube.com/watch?v=5JJJt5-dUAg

    At the end of the test for Samsung 30Q I got a result of 28.73 Wh. Do I need to run the test again?


×
×
  • Create New...