Majnu

Got a refund finally. Are there any guides on how to open it up as I would like to have a go at fixing it? I can see 6 screws at the battery sled area which removes the front surround around the screen and 2 small star screws at the bottom and top of the battery sled but then how do I proceed from there? Thanks edit - okay I remove the foam and the negative terminal screw and the sled slides out, but I guess needs desoldering to come away.

I think it is just safe to request a replacement tbh. I don't want to open it up when it should be covered under warranty. The company I bought mine from has requested a video. Don't see how it shows more than the pics but I created one for them anyway and directed them to this thread.

ok I have just emailed the vendor, shall get it replaced. Thanks

ok I slightly tightened that screw behind the foam and reinserted the battery and now the mod is goiing crazy It flickers; goes through watts and then flashes warranty service with some info.

Just cleaned everything with IPA and connected to Escribe. The batteries are definitely fully charged. I have 2 sets of Samsung 30Q's fresh of charge. I use the XTAR VC4. In Escribe it doesn't show 4.2. Infact it will be easier to take a screenshot.

My Wismec DNA200 has developed a fault The screen has gone very dim and displays check battery. I have tried other batches of batteries that I have and it still displays the same not allowing the device to function. It doesn't show the atty resistance also Any ideas?

cheers vaping bad, my mind is at ease now.

It looks like they knew about the wire issue when reviewers received samples yet didn't make any changes for the production runs.

anyone?

Have I run my batt analyzer correctly? I was told to use 2X 1.5 feet of 24 guage kanthal to make two loops. This gave me a resistance of 1.6 ohms. I ran the test at 50W However I wanted to see if anyone made a video on this and the only one I could find was in French, but I did see that his loop was glowing and whilst mine was running they were not. His shows at 40Watts 1.04ohms https://www.youtube.com/watch?v=5JJJt5-dUAg At the end of the test for Samsung 30Q I got a result of 28.73 Wh. Do I need to run the test again?