[Wismec Releaux DNA200 - resume from standby only by USB plugged in OR battery replacing]

I think, its a RMA issue, too.

But ill research on it. Perhaps Liquid intruded the housing and shorts some electronics on the board.
Not a full short, rather a high ohm short near the fire button. So theres always a higher signal level on the fire button which confuses the Atmel processor.

I´ll dissamble the mod and clean the board with isopropanol.

Will report back if theres a solution.

[Wismec Releaux DNA200 - resume from standby only by USB plugged in OR battery replacing]

I did the Firmware Upgrade / Reflash already and tried a manufacturer Reset and a hard reboot.
The problem persists :-(

The Mod starts up on PC and Wallcharger connection.

[Wismec Releaux DNA200 - resume from standby only by USB plugged in OR battery replacing]

Hello,

I have a problem with my DNA 200 Box from Wismec.
The box is working perfekt until it enters the Standby / Sleep mode after 20 minutes idle time.

Normaly the box starts up, by pressing the fire button.
But my mod doesn´t start up.

I have to plug in USB Power to start it.

-OR-

If i pull back one of the batteries to loose contact, press and hold fire and release the battery back in contact, the mod starts up and i can use it until it enters standy/sleep mode again.

I don´t think there is a firmware problem. Newest Firmware is flashed and manufacturer settings are loaded.

Has someone resolved this problem without sending the board to Evolv ?

I got the mod from FB Fleamarket, i havo so receipt to send it to Wismec / Joyetech :-(


Greetings,

Chris