chris111111

I think, its a RMA issue, too. But ill research on it. Perhaps Liquid intruded the housing and shorts some electronics on the board. Not a full short, rather a high ohm short near the fire button. So theres always a higher signal level on the fire button which confuses the Atmel processor. I´ll dissamble the mod and clean the board with isopropanol. Will report back if theres a solution.

I did the Firmware Upgrade / Reflash already and tried a manufacturer Reset and a hard reboot. The problem persists :-( The Mod starts up on PC and Wallcharger connection.

Hello, I have a problem with my DNA 200 Box from Wismec. The box is working perfekt until it enters the Standby / Sleep mode after 20 minutes idle time. Normaly the box starts up, by pressing the fire button. But my mod doesn´t start up. I have to plug in USB Power to start it. -OR- If i pull back one of the batteries to loose contact, press and hold fire and release the battery back in contact, the mod starts up and i can use it until it enters standy/sleep mode again. I don´t think there is a firmware problem. Newest Firmware is flashed and manufacturer settings are loaded. Has someone resolved this problem without sending the board to Evolv ? I got the mod from FB Fleamarket, i havo so receipt to send it to Wismec / Joyetech :-( Greetings, Chris