I've had my Reuleaux about 3 months, I love the form factor and the consistent TC vape on SS430 that the DNA200 provides. But the other day it just died, mid vape. When I got home I hooked it up to eScribe and it powered on but went straight to WARRANTY SERVICE. I now see that this isn't uncommon, but my symptoms seem to be a bit different. - Pack shows 0.00V with 3 cells inserted - Each cell shows correct voltage - It does charge, and it does balance - It doesn't read an atomizer - Bandgap is 1.009V (or it least it was before I opened it up to look at the internals, now it's higher, around 1.1V) So I'm not an electronics guy so I don't have any testing equipment or even a soldering iron, but I figure I know when something looks wrong so I opened it up. - all wires seem fine - no problems at the soldering points etc. - the fuse isn't blown As I've been typing this, I've been doing some more tests: - if I remove cell 2 (the front battery), it does read a pack voltage - if I slowly insert cell 2, there is a brief moment where it seems to make contact, correctly reads the pack voltage and all three cells and it will detect the atomizer, and is capable of firing - there's a slight "ping" sound when the above happens, but I can't tell if it's from the positive end of the battery as it passes the plastic protection ring in the battery bay or something else - it doesn't matter which batteries I use in the cell 2 position I would understand it being a simple contact issue if cell 2 wasn't being detected properly at all when fully inserted, but it is and charges fine. Any idea where to go from here to fix this? I don't expect Wismec or the online vendor to do anything about this, and I don't think it's a problem with the board itself so I don't see a reason to submit a ticket to Evolv. I'm posting here mainly because you guys are the most knowledgeable when it comes to wiring/connections, which is where I assume the issue is.