I hope someone can help me with this issue because I am going bat S*&$ crazy trying to figure this S%$# out. I made a you tube video of the device monitor in use so maybe someone can help me out will leave a link to video at bottom. So now that pleasantries are out of the way on to the issue. The atomizer I am currently using is the Aromamizer RDTA sitting on a Reuleaux that is housing 3 married purple imren batteries. I have tried a plethora of different builds all with the same result. I have used 3 different types of wire Ni200, titanium t1, and 316l stainless steel. I have downloaded the CSV's from the steam engine and created separate profiles for each. I did not adjust any of the factory setting as far as preheat, punch, time on any of the profiles. The build that is displayed in the aforementioned video is a dual 24 gauge ti coil's 6 wraps 3mm reading .11. The ohms was checked on a Coil Master 521-tab as well as the device itself both showed the same resistance. With all three wire types no more than a second after hitting the fire button the temp protect message start's flashing. I realize that that does not mean the device is not working but pair that with the small to non existent vapor (More vapor is produced out of a generic convenient store e-cig). As far as I know the device is up to date I never received a message the first time I plugged it in to my computer which was a little over a week ago. I know E-Scribe is up to date. My apologies if I left any information out that might be helpful but I am more that willing to provide any info that could lead to the advertised and desired vaping experience. Thanks!! https://youtu.be/wqkC6AHTVuI