I purchased an Hcigar vt200 back in October, It crapped out on me in November (screen would not come on, nothing) Retailer said it was the battery. Contacted board manufacturer and they did an RMA. Had to do a battery recovery and all was well, until last night when I noticed that it had not charged in spite of it being on the charger over night. Now I am stuck with a broken mod once again.? Current situation: Screen comes on battery indicator does not show bolt (indicating charging) Screen comes on without battery and is NOT dim (when plugged into computer) Shows up in escribe Pack : 4.88 V cell 1: 1.64 V cell 2: 1.58 V cell 3: 1.66 V battery had more charge but lost charge while plugged into wall charger (1A eleaf) Charge: 0.000wh USB Power: 0.079W USB Current: 0.015A USB Voltage: 4.814V I inspected the board visually because I read there was at least one issues with smt resistors falling off near the USB connector, but all is well on my board. I tried battery recovery twice with no luck. I checked for anything else that looked burnt or missing with no luck. I tested the resistance of the four resistors to the right of the USB connector and got about 104 ohms each and the one single resistor to the left ohmed out at 5k I am concerned that Evolv will not RMA again in such a short time is there anything else I can check?