chenyunmu

It works for me now but I wonder is it normal that my CVU chip turned into a rough surface. Although i rinsed it with water and rewick it. I find that it turns the cotton black again very quickly like less than 20 puffs with 1-2 sec drag each time on my DNA200 mod tungsten setting 0.00450 35W 400F and 25w pre-heat for 1 second. resistance is locked in at 0.5ohm but im not sure why i still bounce around to 0.6 or 0.7. Do you guys have any method of cleaning the CVU chip though? As I know it is normal for the chip to turn black overtime but the rough dry surface i believe is the residue collected over time can somehow be remove right.

does it taste good with their precut cotton? I heard the review was most people finds it taste bad the original cotton that came with it.

Thanks for the reply. I just tried the steam engine tungsten value have it to set at 0.00450 seems ok but the cotton burnt out and turned black too fast. i think around 20-30 puff it turned black and the juice starts to taste a little burnt. Im using a muji organic cotton and have it have 35w and 450f.

Thanks for the reply..but i dont have a coil in whatever type of wires such as SS, Ti, kanthal, or nickel..cause it is a CVU chip that heat the juices up.

Hmm im using an altus tank..there isnt any factory prebuilt coils..it was the one with the CVU chip "coiless" tank..im also on mobile now i will check the list you haven mention when i have access to the computer..but what i know of for now is im using a vg70pg30 and 6mg eliquid..the coil material im not so sure i think GUO mentioned it was tungsten or something..And a CVU chip which i use MUJI organic cotton to wick it..

Ok I agree I'm noob about all this whole new TC thing ^^ as I just started vaping not long still learning. If you would take a moment to check this file sent by Guo Vape Support you may be able to advice more. I have tried preheat punch at 35w/50w/75w at 1second it still gets overheated quickly and show ohms too high and temperature protected. After ramping up I only take a quick 1-2 second draw not even 4 second. Altus-D.Guos-CSV-8.ecigpr

I got quite abit of problems with this tank and the dna200. Does anyone have a setting for dna200 that can send me. Right now I'm using a setting provided by Guo Vapes 100w 260c 200w 3second preheat punch and 0.0031 setting it burns the coil too fast that im getting dry hits and cotton burning out and turn black within a few puff. Is there anyone out there have a better setting which can send me. Thanks