What i usually do is make sure each of my batteries is at 4.2Volts and then i connect to escribe using HG2 Browns or VTC5s and input 2500mah upload settings check my battery % on the device and it was 96% so i reconnect and go down 50mah to 2450 re-upload and then my meter goes to 100% thats when i know my mah settings are just about correct because i checked batteries with an external meter knowing that theyre 100% charged i set the DNA display 100% i know the discharge curves wont be the most accurate but at least i know i start at a 100% on my meter and run from there by the time i get to 8-9% charge level remaining i re measure my batteries and theyre usually around 3.3-3.4Volts none of that analizer crap heating up and cooling off all night i dont think thats safe .
