Jump to content

siebert.brian

Members
  • Posts

    11
  • Joined

  • Last visited

    Never

Personal Information

  • Full Name
    Brian Siebert
  • Location
    Mt. Vernon , IL
  • What DNA product do you own or plan to buy?
    Efusion Duo DNA 133/200

siebert.brian's Achievements

Member

Member (2/3)

0

Reputation

  1. So you understand when i hooked up the charger it started at 0% . I dont know what happened 1 second like a quarter bar then nothing . I was paying close attention too , one hit then nothing. And you are saying the lipo isn't ruined ? I hate to ask this stuff. I did research but couldn't find what i wanted to know . I guess i will just see what happens. I may have to reboot the device. I went into escribe and changed the soft cell cutoff to 3.09 it was 2.8 , that's what it was factory setting wise .
  2. I was not given a weak battery warning . After a puff it went from before having a little bar to nothing . Next stated check battery , so i plugged it up to charger . The battery percentage read 0% . Did i just ruin this lipo ? I have the settings on escribe set to maximum recharges , so I am confused. No weak battery warning , reads 0 % when first plugged into charger ? Please help if you can. I figured I'd see the weak battery like i seen when using the 18650 sled , but didn't and also since i have it set to maximum recharges not puffs it would help? Why no weak battery warning and did i ruin the lipo by going to 0% ?
  3. The meter reads the lowest bar. And it doesn't change. I haven't tested it again cause ive been working but im going to test it again tonite. By the way. When i hooked up to escribe i restored defaults , then updated firmware , then uploaded settings of 2 cells 2600mah maximum recharge the soft cell cutoff showed 2.8 i left it because with the defaults , update , and calculation thats what was displayed.
  4. Sure I'd like the number. I just got it like 3 days ago, the vendor i bought it from should replace it if i cant get the problem fixed. Also isn't it supposed to show lost vape screen saver after unlocked with 5 clicks or if its sat some time idle then the fire button gets pressed ?
  5. What meter ? Its brand new. Only used it one night at work. With 2 18650s at 72 watts . 5 20 minute vape sessions. When i locked it last it should atleast half battery life full. When i unlocked it about an hour and a half later it should barely a bar , if that makes sense . I was worried that the batteries were drained below 3.2 volts but they were 3.5 when i checked them. Only thing i changed was soft cell cutoff to 3v instead of 2.8v
  6. I just got my Efusion duo. Used it yesterday for first time . When I press the fire button 5 times within 7 seconds it locks the device . I did this then let the device alone for 30 minutes to an hour or so and when I'd press the fire button 5 times within 7 seconds , the device would unlock and show the batteries are drained. I'd fire it a few times and they are really drained. I've updated the latest firmware , uploaded the 2 cell settings for running it with dual 18650's , and I don't understand why this is happening? Im currently doing one more test right now to see if it's the same results? Just put in 2 fully charged 18650's and placed it in lock mode , without an atty on it, set a timer for 30 minutes , and will check it when 30 minutes is up , device sitting idle all the while in lock mode. This is my first DNA device. Am I missing something ? Can someone help , please ? Do I have a defective mod or chip ? I figured lock mode would save battery life , not drain them ?
×
×
  • Create New...