jailin
-
Posts
5 -
Joined
-
Last visited
jailin's Achievements
Member (2/3)
0
Reputation
-
Cheers dude.
-
Cloudmaker DNA 200 I'm starting to see some ballooning on the top and bottom of the 3 cell LiPo. The pack is very firm to the touch. Looking at the 3 cells horizontally there is some swelling so the question is, when is it time to replace the pack and where can I get one in Australia? Photos:
-
7 Wraps - 28g
-
But the coils are glowing in TC and that shouldn't happen no matter what temp
-
Hey there peoples. Been trying to get Stainless "working" in TC for a few hours and I am running out of ideas. :: I have added the material from steam-engine.org's CSV file and edited a profile to change the material to the new 316L. :: I have made a spaced, 0.89Ohm coil :: Did NOT dry burn :: Temp set to 250C and 50w and watched as the cotton burst into flames Using a cloned Kayfun 5 and a Nalu dripper and getting the same results. The wire is UD 28g 316L. Any advice?
