morpheusneo

I have a couple HCigar VT75 that I had put away and haven't been using for a while. I got them out and was going to use one but it is stuck in the temperature setting screen. Normally when you select a temperature or "off" and hit the fire button, it will go back to the main screen where you can select your wattage, etc. Mine does not. It stays on the screen where you set the temperature for temp control even if you try to select off. I connected it to EScribe and restored defaults and it did not work, still stuck on the screen setting the temp. Any ideas on getting it working again? Thanks!

I've had a Hana V200 for about a week or so and I continually get the message about an unbalanced battery. I've left it plugged up to the on board charger through its cycle and it will charge to where one cell is about .2V lower than the rest. I've tried the selection in eScribe to ballance them, it gives me a message about reporting to evolv and then I don't notice any difference but leave it plugged in for hours just in case (I've read it does take a long time). Still after firing the mod just a few times the message starts appearing. Just wondering what I should do. Thanks for any and all help!

Thank you Prot! I feel so silly, that was the problem with the not being able to see the charging screen. It was set to 0. I feel like such a noob. Now I just need to get the cells evened out. Cells 1 and 3 are now at 4.2 and cell 2 at 4.1 so it's much closer. I don't know how close they should be. I know I read it on here somewhere. I will have to do some research.

That very well could be the problem with the display changing when charging. I'll have to check it out as soon as I get back home. I hope so, then I'll just have to worry about fixing the low cell.

I just got a Hana Modz V200 yesterday. I'm loving it and it looks great. I'm just having a couple issues with it. First of all it let's me know that there are unbalanced cells. When checking them in eScribe cell 2 is at 4.05 or so when the others are at 4.2. I hit the forum here and saw where people said to change the display to show the voltage of the cells while charging. I did this in eScribe and uploaded the setting to the mod but the screen doesn't change when charging, it still shows ohms, voltage and temperature. I have it plugged into the computer running the battery reset through eScribe now. I'm just wondering why the changes aren't taking place after uploading and what should be done to fix the unbalanced cells if eScribe doesn't correct it. Thanks!