Triiiple
-
Posts
17 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Downloads
Posts posted by Triiiple
-
-
I think you looked at the wrong vortice, I have no hex screws just two post screws. I will try with a different Atty and see. My vortice is authentic
-
Ok, I did the dry wick test 100 watts 450F and it did not burn the cotton at all it worked as intended. After re-wicking and adding juice the TC stopped working... Ohms jumping around.
-
Is this better?
-
-
I'm building on the vortice v2 and yes I have a resistance issue mine is moving more than .005.
-
Spaced coils still do not work and it's a good build.
-
I do not have a spaced coil
-
-
-
Temp is working again except it gets too warm around 130°F.. Same problem
-
Yes I loaded the correct one and I'm on the right profile, I am certain. As of now my device won't use any type of TC and it thinks my Ti is kanthal. Do I need to add something to the "special" tab on Escribe?
-
My device still runs hot at low temps.. Here is my graph
-
Ok, I will try it with that CSV file, I think I had version 1, and I will check my leads and get back to the forum.
-
I'm using sweet spot vapes .5 Ti wire (http://www.sweetspotvapors.com/product_p/tiw0.5.htm) and I am using the corresponding CSV file for that sweet spot vapes wire.
-
My device seems to work with temp control, but when I fire my RDA with titanium it gets really hot and burnt like at 100-200°F so them temp control is almost pointless.
Vaporshark dna200 problem
in General Discussion
Posted
Ok I will check my connections