Subohmn

Flashed a few times, even went back to the appropriate version of escribe to do it. I didn't pay attention to the "get info" to see the age but it's a flawless mod I converted for someone so I assume it's pretty old.

Built a 133 with a 2s lipo and once it goes into sleep mode it won't wake up unless I plug in the usb, after it's unplugged it'll work fine unless I let it go back into sleep mode. If it matters, escribe is seeing 4.2v in cells 1 and 2 and 1.12v in cell 3. It is set to two cell mode and I have cell 2 and 3 bridged at the board. Solder joints are good and I've tested at pad 3 with a meter and it's even with cell 2 (obviously). Battery is an 1800 mah maxamps. If anymore info is needed just lmk.

As he said, upon install make sure you check the box for drivers, did you do that?

Uninstalled escribe, reinstalled, works perfect. Thanks Vaping Bad, your the man.

So I plug in a dna250 (just got a few in) and escribe says "no compatible usb devices are connected". But the mod is charging while plugged in as I'm getting this message. Any reason or logic behind this? Also, I've plugged in a few other dna200's and it recognized all of them (with the same cord).