[Incorrect ohm reading with 1.2 sp3]

Daddi89 said:

So I'm not the only one... Frankie what atty are you using? Ps: nick confirmed me there weren't any changes to the ohms reading between the old and the new firmware.

For my tests, I tried the Kayfun v5 original and the SJMY clone with single, simple nickel and SS316 builds. The 0.09 ohm nickel coil was reading as high as 1.12 ohm. So to do further testing I also tried OBS Engine and Reaper Plus with dual SS316 builds, and got similar results. As for sending the board back to Evolv, right now its working ok with the old firmware. I figure I should leave it be and just use it until the new release.

[Incorrect ohm reading with 1.2 sp3]

I started experiencing incorrect (continually changing, always much higher than actual) ohm readings with my S-Body Nuke after upgrading to SP3. After burning a few wicks, I opened the mod casing and tightened the 510 connection and upgraded to SP4 but still had the same issue. After downgrading to the 02/2016 version, its back to its rock solid self and working as perfect as my calibrated Ohm meter is.