This may be just a generic lack of knowledge, and I can find very little info on using temp control with Ti wire. I am using SSV .5mm wire, I loaded their CSV off of their website, and everything seems to work fine except I get barely any vapor production before I hit the temp ceiling. For ease of my first time I used a single coil it was steady at .35 ohms. I set it at 350 F and I could get about a half a second hit before I hit the temp ceiling. This was at 110W. So I dropped down to 60w let it sit for a second, then tried again. Same issue I hit the temp ceiling extremely fast. Raised temp to 450, Got the same issue. At this point I plugged into eScribe and made sure I had no shorts or other issues with the coil. Cold Ohms were same on the device as on my Ohm meter. Anyone have any idea on what I am doing wrong. Oh device is the Madvapes Templar.