inspector
-
Posts
12 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Downloads
Posts posted by inspector
-
-
So i resoldered the 510 connector and it still reads 2.08+- for the pre built 1.8 ohm coil. Don't know whats wrong...
-
It doesn't fluctuate when in use but sometimes if i leave it for a while then fire it again, it might jump to a higher ohm then if i leave it again and fire another time it will be the first ohm reading.
Edit: like right now im using the same coil as last night reading at .36, right now its reading .39.
Edit 2: well then lol, took a hit and the coil snapped (from a short maybe), it was working fine for the pass two days though -.-
Edit 3: I put in a pre-built coil at 1.8ohm, but the device reads 2.02ish but its jumping up and down from there so i guess it is a bad connection. Mod surgery time
-
Im using a fatdaddy 510 connector. The connections look fine, im using 14awg wire. How would i test/know if its bad?
-
Ok so i did the case analyzer and checked the mod resistance (got .02). The vape is still real cool. Currently i have it set to 580F to get a warmish vape. Is this normal?
-
I didn't know about the mod resistance. How do i set it accordingly? And yes the resistance is close enough on each, off by .01-.03.
-
I have been wondering if the temp my DNA200 is reading, is correct. It seems that 450F is a lot warmer on another mod(IPV3) then mine, both using the same tank and coil. How do i test to see if the temp is correct?
-
Yea it prob is shorting against the tank walls. I just ordered 32awg wires to test out, if not i might need a bigger tank.
-
I get .24-.28 ohms. Most likely not the insufficient tightening issues, might even be too tight as i go all the way to where it almost clips the wire(comes off with one twist).
-
I have a question about coils also, so im new to building coils, i have an aspire triton tank. I used 30 gauge ni200 around a 3.5mm rod for 8 wraps. When i fire it, the positive leg seems to short (burn), sometimes it even melts the wire. Then when i do get a coil to not burn it seems to get to temp control real quick (450F), also the vapes are real cool through out. I have it on 25w with pre-heat at 200w for 1s. Is this normal and any advice to prevent the shorts or what ever is happening?
-
Just finished my build after weeks of waiting and reprinting the case.
-
I would also like to know how i can edit the case, im new to 3d printing and i couldn't get the case to save as a STL file in inventor 2016. End up making my own model with the measurements.
Temp control
in Manuals, Instructions, and Tutorials
Posted
What do u mean add?
I just re-soldered with new wire and solder.