badow24

Okay in 2s mode does it work well for temp control? Or do I need the full 200 watts. I was using the crown tank with the .25 coil and at 80 watts it was a nice vape. But with this .15 nickel coil, temp control doesnt seem to appeal too much. I have the preheat at 133 watts. Punch at 11. Timeout at 1.5 sec. Watts are set at 80 watts and temp at 520. Seems rather weak. Like the heat and clouds like the .25 coil instead.

Haha isopropyl. Or rubbing alcohol.

Haha whoops before I desoldered the power i cleaned it. Then plugged the power in to test

Okay thanks. I am trial and erroring right now. I took the board out and desoldered the external switch, tested and no change. Then desoldered the out and gnd, tested and no change. Then before I disconnect the power I cleaned the board with rubbing alcohol and now the board is working. So i hope something as simple as that fixed it so I am going to put the board back in and hope it keeps working.

Hey got the same problem wojzilla. Ever figure out your problem?

Cant really get a closer look at the soldering but im postive there is no solder there. Also i am using onboard firing buttons so no solder around there. Funny thing is I use the device monitor and simulate buttons and use the fire button in escribe it works fine. Fire it and change the wattage. But as soon as I leave device monitor and disconnect from escribe the fire button doesnt work and like i said the up down buttons will fire and keep firing. Also in escribe in device monitor the screen dims and functions properly. Not connected the screen stays full. Thanks for the reply

Hi I made a custom 1590g mod. All soldered up. Used escribe and set to 2s. Dna200 turns on and fire button unresponsive. I have external switch. Switch works fine. But when I have a atty on there and i hit the up or down button it will autofire then i quickly have to take tank off or hold one of the up down buttons and it will quit firing. It also says warranty service when it starts up. I have 2015-10-21 EScribe 1.0.35.2 installed. I even tried other firmwares. Using escribe and the simulate buttons it works but on the mod fire button doesnt say anything and up down all they say is check atomizer. Thanks for the reply