Proto

Ok, so it was my fault, idk what happened but i just resoldered my wires and connections and the temps dropped to 80~

Wait, i just re-plugged it and it was below 120 and still at 0.1amp... wtf this chip is crazy.

I think you're right, i'm not too sure what a Fahrenheit is because i work in Celsius. I plugged it in again and it worked fine till it hit 125f And apparently my room is 43 degrees... i'll have to take it apart and check the soldering.

It's consistently only ever charging at 0.1amp. I've tried different cables and sources but they are all the same. i have other setups that are identical that charge just fine. I've tried a full firmware reset and tried changing the charge current in the monitor screen. I made a few of them and this is the only one doing this, it seems like a software thing because of how consistent it is, i can limit the usb current to 0.05 and that works just fine, it just won't raise higher than 0.1 It just started only doing this recently, I've had the batterys fully charged before from the devices usb port and they were working just fine, my mate said it was only charging at 0.1 and he gave it a wiggle and it fixed it but i didn't get to see so i really don't know. I might take it apart and resolder it but i really don't think that's it. Spec: Dual 18650 30Q DNA 200 in dual battery 133mode Edit pic: