[75c "Replay" update missing feature ??]

1 hour ago, James said:

@neX, the 75C does not have the signal-to-noise ratio to make "Allow on dubious coils." reliable for most coils. The 250C has an extremely clean signal.

(Among other reasons, voltage step-down-only (250C) has lower noise than step-up/step-down (75C). Reviewers etc. tend to treat step-up/step-down as a feature but it's really a tradeoff. One that makes sense for a single battery mod, but a tradeoff nonetheless.)

For your Clapton coil, if it is a mix of Kanthal and Stainless, more Stainless should get you into a usable range.

Also, some coils and some wire are marketed as Stainless when they are not. To objectively find out, check Device Monitor. How much does Live Ohms change during your puff with the dual coil? For a real Stainless coil, you should see about a 20% rise in Live Ohms from cold. Real Stainless coils should work with no problem at all.

So because my coil is Ni80 the replay button doesn't even show up?

[75c "Replay" update missing feature ??]

47 minutes ago, Moutainvaper said:

Just uploaded the default and it solved the issues listed above!  Just make a "watts" profile, check the "use Replay on this profile" and you are off to the races!

I did that. My problem is the replay button won't appear. It's just a blank box.

[75c "Replay" update missing feature ??]

I see the feature but it's not allowing me to "record" the box just stays blank. Is it because I'm using Ni80?