[Why are these so slow to come out????]

alee132 said:

Wow 1000mah in 1590?  That's damn good. I barely could fit a 950 and that was with a faceplate and I had to remove somethings to make it work. Wonder what battery you will use.  Very interesting.

https://instagram.com/p/5xDeB4AWCs/?taken-by=xevape

There we go.   Had to mill out the top of the case but its in there working/testing.

Thank you

[Come Work at Evolv]

Brandon check out my solder work instagram.com/xevape

Let me know if you have a position in repair or something.   I have a 9-5 however always looking for more work for the house of my dreams for my wife and daughter.

Thanks buddy.

[Why are these so slow to come out????]

www.xevape.com will have 3 models coming out soon.

1590A 1000mah
1590G  1000-1500mah with desired halo buttons
1590B  2200mah with desired halo buttons

I'm working on a 1590A at the moment putting the finishing touchs tomorrow.   Its over in the general forum.

[Let's see your 200's!]

Brandon said:

The audible clicks would drive me nuts. 

The clicks makes me feel more manly.    I also took apart the original buttons and retrofitted the tact buttons to make them non audible clicks but that's a whole nother' story.

[Let's see your 200's!]

Always_Jonezen said:

[QUOTE=xevape]I was not a fan of the onboard buttons....so I replaced them    @XEVAPE

    

Is that a Hammond 1590a? Man that is a tight fit. NICE WORK LOOKS GOOD. I'm fixing to start working on my 7th DNA200 and it will be in a 1590a I hope mine turns out that nice [/QUOTE]

The top of the case does not fit, yet.   I'm going to mill out the edges tomorrow at work and hopefully it does after.  Also the 510 pushs against the lipo so I'm going to have to figure something out for that factor.    However if you need small this is legitly the tightest fit you are going to get.   The tact buttons make it so that the board fits flush and the Lipo holds it all in place.   If I were to do it over again I would make certain that the lipo doesnt get in the way of the 510 however I, again, am going to try and do something about that tomorrow...Good luck and be careful.

[Let's see your 200's!]

Brandon said:

How dare you!! 

Should have been designed with these buttons,  just saying

[Let's see your 200's!]

I was not a fan of the onboard buttons....so I replaced them    @XEVAPE

    

[Removing the DNA 200 Buttons and replacing with Tactiles]

[Advanced Soldering]


https://instagram.com/p/5vV3PNAWNI/?taken-by=xevape

https://instagram.com/p/5vZjK4AWDK/?taken-by=xevape

https://instagram.com/p/5vZ0HUAWDp/?taken-by=xevape

https://instagram.com/p/5vZ0HUAWDp/?taken-by=xevape

https://instagram.com/p/5veO9yAWMU/?taken-by=xevape

Came out pretty damn good...just gotta finish up the case tomorrow.

-xevape