Shaylon
-
Posts
4 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Posts posted by Shaylon
-
-
I also just recieved a charger that is supposed to do 2 ports @ 5v & 1.2amps and 2 ports @ 5v & 2.4amps. No matter which port I plug into I only show 0.39amp charge on the board screen. How do you get it to pull 1 amp?
-
Brandon stated in another thread...
Quote:Originally Posted by Brandon
The 200 powers off (hard sleep) after about 1 hour of non use.
Is it possible that a hard sleep would prevent charging?
I put my unit on charge at 3pm yesterday with 40% battery remaining.
This morning @ 5:30am I was @ 82% charge. After messing with things and reading here I figured out to change the charge screen to show % charge, USB Voltage, and USB Current. I also set the charge brightness screen to 63. Within 1.5 hours I am fully charged now. 14.5 hrs to move from 40-82% charge and 1.5 to move from 82-100% something seems off here. -
Brandon said:
The 200 powers off (hard sleep) after about 1 hour of non use. James can probably give you the exact time.
Is it possible that in the latest firmware that hard sleep would prevent charging?
I put my unit on charge at 3pm yesterday with 40% battery remaining.
This morning @ 5:30am I was @ 82% charge. After messing with things and reading here I figured out to change the charge screen to show % charge, USB Voltage, and USB Current. I also set the charge brightness screen to 63. Within 1.5 hours I am fully charged now. 14.5 hrs to move from 40-82% charge and 1.5 to move from 82-100% something seems off here.
Charging question
in Batteries and Charging
Posted
I am speachless. I feel kinda dumb now. Thank you so much. I tried a different cable and am now pulling 0.96 amps. Poor cable it is. Again, thank you very much!