Jump to content

Shaylon

Members
  • Posts

    4
  • Joined

  • Last visited

Shaylon's Achievements

New Member

New Member (1/3)

0

Reputation

  1. I am speachless. I feel kinda dumb now. Thank you so much. I tried a different cable and am now pulling 0.96 amps. Poor cable it is. Again, thank you very much!
  2. I also just recieved a charger that is supposed to do 2 ports @ 5v & 1.2amps and 2 ports @ 5v & 2.4amps. No matter which port I plug into I only show 0.39amp charge on the board screen. How do you get it to pull 1 amp?
  3. Brandon stated in another thread... Quote:Originally Posted by Brandon The 200 powers off (hard sleep) after about 1 hour of non use. Is it possible that a hard sleep would prevent charging? I put my unit on charge at 3pm yesterday with 40% battery remaining. This morning @ 5:30am I was @ 82% charge. After messing with things and reading here I figured out to change the charge screen to show % charge, USB Voltage, and USB Current. I also set the charge brightness screen to 63. Within 1.5 hours I am fully charged now. 14.5 hrs to move from 40-82% charge and 1.5 to move from 82-100% something seems off here.
  4. Is it possible that in the latest firmware that hard sleep would prevent charging? I put my unit on charge at 3pm yesterday with 40% battery remaining. This morning @ 5:30am I was @ 82% charge. After messing with things and reading here I figured out to change the charge screen to show % charge, USB Voltage, and USB Current. I also set the charge brightness screen to 63. Within 1.5 hours I am fully charged now. 14.5 hrs to move from 40-82% charge and 1.5 to move from 82-100% something seems off here.
×
×
  • Create New...