JoshBali
-
Posts
3 -
Joined
-
Last visited
JoshBali's Achievements
New Member (1/3)
0
Reputation
-
Need file EScribe default Finder133 Pls
JoshBali replied to zronous's topic in EScribe, Software and Firmware
Just click 'Restore Defaults' on the General Tab in Escribe. This will reset your device to the manufacturer settings. -
preheat kanthal dna75 (2022) Just use Boost Punch
JoshBali replied to abraxas's topic in EScribe, Software and Firmware
After this add the new wire to your Kantal Preheat profile. The pic shown below is from a profile on my Finder 133 but its the same on a DNA75 (except the 80 watts preheat... just make it 75). For big coils like claptons I set the punch to 11. For normal ones 5 or 6 will do...
-
preheat kanthal dna75 (2022) Just use Boost Punch
JoshBali replied to abraxas's topic in EScribe, Software and Firmware
Hi there Im using the attached material csv and the ecigprofile for Kanthal preheat on my Therion 75 and on the Finder 75 for my Clapton coils to cut down the ramp up time. Its working 100% so far But appart from this I would appreciate a option to set a preheat punch in non TC profiles too. kanthal_Preheat.ecigpr Kanthal_A1_preheat.csv
