Danno

The manual also tells you how to lock the ohms. Wtf else would it be used for...kanthal? All these threads about getting ss316L to work right and you post "I thought the manual said...". We must be illiterate idiots. Thanks for being helpful and pointing that out. We should have read the manual.

I was struggling with ss 316L for a bit. I have a panzer dna 200. My issue was a weak vape after device rests. What i have figured out to work perfectly.on my aromamizer is : Download djlsb vapes ecig profile and upload it to the device. Build contact coils 7-9 wraps each. Prepare them at low wattage. Get it to glow just enough. Careful with the sudden hot legs while shaping the coils. Wick and wet. Don't use too much cotton. Let it sit a minute to normalize temps. Get your device ready and connect with escribe. Go to your ss316 profile. Detect you cold reststance ( I usually end up around 0.17 and 0.19 ohms). Lock your ohms. Check temperature dominant. I set my temp tp 460-470. Watts to 65. Preheat power to 1w. Yes one watt. Upload settings. Back into the profile and adjust/override the atomizer resistance. Add 0.002 ohms at a time. Adjust, upload, and then test. Rinse and repeat. 4 to 6 attempts should be enough to narrow it down. Thats it for settings. If i have issues after the prep process above I check my coil connections. After about 3 tanks I change the wick when i clean the coils. About 3-5 coil cleanings and its time to replace the coils.