battery analysis failed insufficient samples

[tehdarkaura]

So i get this message when I try to test my battery -- I am using two 1 ohm 100 watt resistors in parallel 

not sure what the issue is -- any advice would be appreciated.

I am using a laptop and a longish usb cable... not sure if that could contribute to this sort of issue.

 

[tehdarkaura]

I used a different USB cable and it worked fine!
Thanks!

[Niet]

Hi,

I got a new squonk mod with DNA75C, same issue whatever the usb cable used.

EScribe version 2.0 SP 15.1 INT

Firmware 1.1 SP 33 INT

if someone knows how to perform a battery analysis, could he share how to proceed ?

Regards

Edited May 7, 2018 by Niet

[SManBoris]

It was several times. Replaced the wire, but the launch from the second time only. Unclear.

[lazybones]

I had the same issue, it was resolved by;

1, plug mod into e-scribe,

2, turn mod on (while plugged in)

3, measure resistance of the test atomiser (also while plugged in)

worked fine for me after that.