Jump to content

timinho111

Members
  • Posts

    12
  • Joined

  • Last visited

timinho111's Achievements

Member

Member (2/3)

0

Reputation

  1. Perfect, this was the final adjustment needed. I matched the Fill Pod settings from the 1.2 and 1.6 and now I can do 12W with the detected 1.6 and its not telling me to "Fill Pod". Thanks a lot again!!! You can hide this now I think
  2. Will try this tomorrow (from Germany so already 8pm here and need to bring my kid to bed haha). The hiding is totally fine for me. I get your point. I also saw you replied on reddit to my comment. Will delete the link to this topic also from there to have no links to this post on there.
  3. It registers as 1.2 Ohm with your settings. But like my edit said: Its then really unusable since I can not pull at all (always "Fill Pod"). I also tried something else and just set the "Max Power" to 12W on the 1.6 Ohm with the regular settings. But also 12W with the registered 1.6 Ohm lead to "Fill Pod". So for now it seems that I just have to live with 10W max and a 1.6 Ohm registered coil.
  4. You have been a great help! It works! THANK YOU VERY MUCH! edit: ok was too excited a little early it now shows "Fill Pod" every time. It correctly detects it as 1.2 Ohm now, but directly shows me fill pod when drawing.
  5. I did and nothing changed.
  6. I did. I tried the OXVA + SP67 first. Now the INT + SP67. But no change. No prompt to update and both have Version 1.1 SP112.2 INT in the device monitor.
  7. It is actually the latest. I reinstalled everything but still no prompt to update to the latest firmware. v111.2 is also shown in the update guide from OXVA after upgrading the firmware: https://drive.google.com/drive/folders/1FE5YjxetLt6gWtCrLSOU6wESZCubpTiS (from the Media Kit of the OXVA page). So pretty sure its the newest one.
  8. Like I said in my first post: v111.2 on the device when turning off Device Monitor shows: Version 1.1 SP112.2 INT in the bottom right.
  9. Ok its not possible to change any settings concerning power/wattage in either Mod (read-only fields) or General (if I set to 12W it does not change it on the mod even after uploading it to device)
  10. Thanks, this helps, will try it tomorrow! Very likely its crud on the coil since the liquid seems to be very sweet (Drip Hacks Alkaline Rise, can see the liquid getting brownish once the misreading happens so probably caramelized in there). The crud is probably also the reason for the dry hit detection not working probably I assume. Is there any way to improve this any way or do I just have to live with it? If I find a puff where its not telling me to "Fill Pod" I press the replay button and this helps but this is just a workaround....
  11. I've been using the Xlim DNA for about two weeks and have two major issues: I am using the 1.2 Ohm SS Pods. In the beginning its all good. After around 400-500 Puffs the Pod is ALWAYS detected as 1.6 Ohm Pod and I can only use 10 Watts maximum. Also starting at almost the same point the burn protection goes off and tells me to "Fill Pod" even though the pod is full. It tells me that for every second puff. Like this device is close to being unusable. I am on firmware v111.2. I think the "Fill Pod" issue was also with the 0.8 Ohm which was sent with the device but not 100% sure. Any ideas? Would be greatly appreciated.
×
×
  • Create New...