Hill-Billy-Huck

Are you willing to test it for me? Can you see if you could connect to the serial port and set a temp to 100 degree F for either the preheat, or fire feature?

How does "preheat mode" work? Can pre heat mode be temperature controlled? If so, that would be adequate. So, can I use preheat mode, to set the coil to 100 degrees, and leave it at that temp?

10 seconds should be adequate, the longer the better tho. "Session mode" would be great, but not mandatory. Is there a way I could obtain the source code to modify the firmware myself?

I am doing research into atomizers, and I need to build a device that will maintain 100 degree F. I'm going to have to build my own device to do this, and I was thinking of using a DNA chip to do so. DNA chips are able to put out as little as 1 watt. Which is a low enough value to heat a coil to only 100degree F. So I'm confident that the DNA chip is capable of producing the low temperatures I want it too, but can it use Temperature Control to maintain those temperatures while its being used? The DNA chips all quote a minimum temp of 200 degree F. Can I modify a DNA chip to make that minimum value even lower, to 100 degree F? I see you can use a MICO USB cable to connect to some of these chips. Could I just connect my computer to the chip, and then just modify a few lines of code to allow 100 degree F temp control? Can I just modify the software? If not why? Is there another chip that can do so? Is it possible to build a chip that fulfills this purpose? Thanks!