vape vape

Micro usb.

It is not recognised when the battery is removed and tried. Other dna60 devices are recognised, but only one is not. Is there a chip fault?

I bought a dna60 device. When I connect it to the escribe, it charges but does not recognise the device. I use the cable for transfer. Trouble.

I would like to reproduce it on my device but can't.

What do you mean? A little more detail would be helpful.

When does the NEW COIL appear as shown in this image? I have been using DNA60 for 3 years and have never seen such a setup.

This is DNA 60. I get this screen and the wattage keeps dropping and I can't operate it.😭

I get this screen and can't operate at all. What is this screen?

0.03 resistance drop and stabilizes at the low end Sorry it took me so long to get back to you, thanks.

0.03 resistance drop and stabilizes at the low end Sorry it took me so long to get back to you, thanks.

This is the mod screen.

This is the case for all coils. But it doesn't happen with anything other than the billet box.

Hello! Thank you for yesterday! Dry Fire is running properly. The other mods are stable, but only the billet box has a slight drop in resistance on the first firing.

For some reason, when I press the button to heat it up, the resistance drops a little. Normally the resistance should go up when heated, right? After it goes down, it stabilizes, but why does the resistance go down a little only at the first heating? I'm using Kanthal wire. And I use it in orthodox power mode.

I'm looking! The billet box is 0.07Ω more expensive than other DNA mods when built with Kanthal.😭