[Temperature Protection in watts mode]

I am definitely saving these replies.  What I am assuming is it was do to a setting from something I downloaded into the mod.  What I did was restore the mod.  I then did an update and reinstalled a theme I liked but did not miss with any other settings.  I also realized when doing that I forgot dry fire and remove the hot spots from the coil so I am assuming that played a role in it.  Just from the fact I have seen coils vary after being dry fired for mech mods.  Thanks for taking the time and helping out!!

[Temperature Protection in watts mode]

I just tried a different mod it’s only when I get up to like 80 but works fine on any other mod so I’m confused

[Temperature Protection in watts mode]

If I put on a sub ohm it works fine but only using 65 watts. The rda I’m pushing 90 to get a vape. I know the ohms change a lot when I fire it. The pic below is the one giving me the error.  Works fine on my Ursa Quest. Hope someone can help.

[Need help with error. (Curve must be strictly increasing)]

That solved my problem! Thanks for the help.  I had over looked the curve apparently. 

[Need help with error. (Curve must be strictly increasing)]

I downloaded some themes from this forum and its obvious they work for others.  I have tried everything but I am fairly new to the software.  I uploaded themes before and didnt have a problem.  Could someone please direct me in what is throwing this error.  Is it from maybe trying to make a material curve before?  I do not have anything I am worried about keeping.  Any suggestion would be appreciated.

thanks!

Nick