[DNA GO tech sheet?]

I have the same problem as you. I hope to find out the phase information about DNA go chip.

[Help for Neo go mod/DNA GO！]

57 分鐘前, dwcraig1說:

I would recommend using NiFe 48/52 or Stainless Steel 316 for your builds, Kanthal or Nichrome would be a lot of mass at 0.25 ohms.

O.25 ohms would be a good target, even slightly lower as the resistance increases with these wires as they heat up. 

Your suggestion is very good, but I usually use MTL instead of DL, so the resistance range I set is generally 0.65-0.85Ω.Kanthal or nickel 80 is the most commonly used for me. For my opinion, 3.5V for some juices, it is difficult to stimulate the whole taste. 😓

[Help for Neo go mod/DNA GO！]

35 分鐘前, dwcraig1說:

Your figure of 3.5 volts output (max) is right in the ballpark, you must use lower resistance to be able to achieve 30 watts/ 40 boost. 

https://www.the12volt.com/ohm/ohms-law-calculators.asp

As far as battery sag/voltage drop be sure to use the most powerful 18350, Vapecell 9 amp or equivalent.

Thank you for your reply.

To be honest, I feel sad that DNA go can only reach 3.5V.I would prefer to have at least 3.7V.

[Help for Neo go mod/DNA GO！]

Hello guys, My Neo go mod needs some help.

I noticed that no matter how much resistance my atomizer is , the output of mod can only reach up to 3.5V when the battery is fully charged. For example, my coil resistance value is 0.7 ohm，Even if I set 25W or 30W on the escribe, the actual output can only reach up to about 17.5w (or even lower), and the output voltage and output power will always decrease with the battery level.

I wonder if DNA GO chips can't achieve constant voltage and boost voltage? Is the maximum output voltage of DNA chip (or my Neo go MOD) only 3.5V? Or is there something wrong with my settings?

In addition, I can't find a specific introduction to DNA go chip. Can someone give me a link to relevant information?

Thx for your reply！

Moderator Edit: I have merged your duplicate posts. You can hide one if you wish.

[Help for Neo go mod/DNA GO！]

Hello guys, My Neo go mod needs some help.

I noticed that no matter how much resistance my atomizer is , the output of mod can only reach up to 3.5V when the battery is fully charged. For example, my coil resistance value is 0.7 ohm，Even if I set 25W or 30W on the escribe, the actual output can only reach up to about 17.5w (or even lower), and the output voltage and output power will always decrease with the battery level.

I wonder if DNA GO chips can't achieve constant voltage and boost voltage? Is the maximum output voltage of DNA chip (or my Neo go MOD) only 3.5V? Or is there something wrong with my settings?

In addition, I can't find a specific introduction to DNA go chip. Can someone give me a link to relevant information?

Thx for your reply！