-
Posts
11 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Posts posted by Ryan Brooks
-
-
Well, I got that sorted out, but now I have a eeprom error.... I'm about to give up after pulling out what little hair i have left..
-
I see, I'm currently running the case analyzer at the moment. I just wanted to make sure there wasn't something else important that I was supposed to do during the initial setup, since the last time i put one together I had a usb charging problem. Thank you for that information.
-
Not to hijack this gentleman's post, but I just got my first box together and I was wondering if there was anything special that I needed to do through escribe for the initial setup, or if there were some settings that I'd have to play with first.
-
I'd post pictures, but I got irritated and pulled it all apart and resoldered it, but I did have everything soldered up correctly.
-
Well, I pulled it apart, and soldered a jumper wire from 4 to B+, but it's still not charging through the USB.
-
Hm, I didn't run a jumper wire to the fourth pin, I didn't think I needed to worry about the fourth pin... I suppose that's what I get for not checking a wiring diagram. Now, I'll have to try and undo the JB weld I used to hold in the chip holder...
-
I"m using a 3s, I switched the config in the Escribe, and I see voltage coming from the USB, but not charging the battery.
-
31 minutes ago, KMac said:
None I did the all the calibrations ie the battery analyzer and case analyzer.
Replay doesn't seem to like my Steam Crave Titan no matter what build I use but using a Kylin it's working flawless.
I can't do any of the calibrations, since the battery won't charge....
-
I see.. Which battery are you using in your build?
-
Have you had any initial battery problems after getting all together?
First DNA250C Build HELP PLEASE!!!
in Modders' Forum
Posted
And, none of the buttons do what they are supposed to.