JJVapes

I'd buy this

I got everything going thanks guys

I will after work. What size screw should I use? 1/8 20? I made some twisted pairs at work I'm going to try installing when I'm home

I've tried it in both my twisted messes and velocity rdas. I'm going to spend some more time trying to get it built today. I know it's me messing up something I just gotta figure out what. =(

I've done both spaced and tight and got the same results. Do I heat up and squeeze out the hot spots on the nickle with a normal mod or no?

Yea but I'm firing it up and the watts are jumping everywhere. The highest they are hitting is 37 before it shoots to 0 the. 9 then 0 ect

I've watched the tutorials online and done everything they have done. I have 30g ni200 wire doing 10 wraps on a 1/8 drill bit rounding out at 1.2 for dual coils. All I keep getting no matter how many coils I build is temperature protected. It's driving me nuts. HELP

I'm going to cut a drill bit and use that

I'm just looking for caps to go over the buttons.

I saw that and I was gently trying to pop it but I was worried about breaking it. Thanks

Thanks yurlosin

I tried what you did in the video pod but it doesn't seem to get in deep enough to stick. Does it click into place or give any indication of being secure?

Could some one post a picture showing me where they connected their 510 power line to the board? I'm pretty sure I know from the manual but I want to be positive. Also will the board being g grounded be enough for the 510 or do I need to sauder a ground? If I need to sauder a ground on I'd like a picture of where to do that too please. Thanks

Thanks john

Thanks man