bazhanov236
-
Posts
4 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Downloads
Posts posted by bazhanov236
-
-
scoopy said:
RIPs wasn't running that low....It was either 0.08 or 0.06 I think BUT it WILL go that low but the lower u go the lower your watt limit will be.....I think if I'm not mistaken u r limited to 50 watts when running a 0.04 build.....technically you can build down to damn near a dead short but like I said The lower u go the lower your watt limit will be.The 0.08 limit is the lowest u can go and still have the full 200 watts...Hope this helps and good luck with your shark!
Thanks guys! No he was he built two claptons 03 on 04 nickel. So now i built 0.04 ohm single clapton on snow wolf it told me low,i presset fst and it became 0.05) I think i can calm build nickel coilporns on dna200))) And maybe Rip will explain this in future reviews -
Gm111 said:
If you've entered the csv file from steam engine you should be able to run it too what ever temperature you normally vape at, you only use different temp on yihi chips because it doesn't know what Ti is.
R u kidding? In latest yihi is choise between ti or ni200 as mini m class or ipv li. Whatever i use this lower temp settings on snow wolf
-
Hi guys. From Russia with love)) Just waiting for my preordered vaporshark.Saw Rip Tripers dual ni200 clapton build for dna200. Resistance was 0.02 or 0.03 ohms. So,why everyone sais that there is tc resistance limit such as 0.08 ohms? Maybe it's 0.01 ohm in ni200 tc mode? If I need to set this feature in Escribe>tell me how to get this sweety thing) Or it's standart?
Titanium coils
in General Discussion
Posted
Scoopy you re here too) So everytime i build ti1 coil i need to make new csv file on wire wizard? Or there is ti file which allows you to dowload it in profile and don't care about wraps,mm's