[Discharge profiles for WisMec ReuLeaux]

So, does the battery type need to be set to lithium polymer, or lifePO4 battery?? I've read use the lifeP04, and i've read lithium polymer...which is it?? 

[Opus 200 dead]

My opus just died for the 2nd time.. It was working fine, then nothing.. I was using a nickel coil in my crown tank, 50 watts at 530°... Blank screen, don't charge when plugged up, and won't connect to Escribe.. I'm at a loss...

[Black Screen]

Same thing here.. Just got my Opus 200 back from being repaired less than 2 weeks ago. Today I was vaping, decided to use a nickel coil in my crown tank.. Everything was fine, then I went to take a toot and nothing.. Blank screen, escribe don't see any device connected.. I'm at a loss.. I've emailed Opus, now I'm just waiting.. :'-(

[Early Firmware and EScribe Suite Discussion Thread]

laadam said:

That makes sense.  I did not notice a version change when you click on "Help" and "About EScribe"
I may have just recalled incorrectly...
What version do you show? I'm at 1.0.33

Mine shows up as 1.0.32

[Opus 200 dead]

John said:

This is becoming an upsetting trend. Before you send it to Opus can you connect it to Escribe and take a screen shot of the device monitor? 

My opus did the same thing about an hour ago.. Won't power on unless plugged in via USB, then gives the error message ohms to high.. I have the black version

[Help please, no power unless plugged in]

My opus 200 started saying ohms too high. I've been using the pre-built ni200 Crown coils with no problems.. I put a new coil in the base, that's when I noticed the mod had nothing on the display. If I plug it up to the usb charger the display comes on.. As soon as I unplug it, it cuts off again? Please help **I put my Arctic Tank with kanthal coils on the Opus and it's saying the same thing.. Ohms too high.. I just updated the firmware last night.. Haven't had any problems up till now..

[Help Board comes on when usb plugged but still won't fire.]

I'm having the same problem on my opus.. Just updated last night, now having the same issue as you.. Thinking the fuse is blown?? Waiting to hear back from someone from evolv now...

[Please Help]

my opus 200 is acting up.. It started saying ohms too high, I've been using the pre-built Crown coils with no problems.. I put a new coil in the base, that's when I noticed the mod had nothing on the display, but if I plug it up to the usb charger the display comes on.. As soon as I unplug it, or cuts off again? Please help **I put my Arctic Tank on the Opus without the tc on, and it's saying the same thing.. Ohms too high.. I just updated the firmware last night.. Haven't had any problems up till now..