West84
-
Posts
17 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Posts posted by West84
-
-
2 minutes ago, Wayneo said:
I sure do believe you are correct. But I'm old.
For a guaranteed correct answer, the pinouts are also shown in the datasheet for the 60.
Yes,I know that,pinout is ok. I just wondered is there need for every button to connect the negative because I've seen somewhere that negative is internally connected
-
Please,I need help with wiring external buttons. Is this ok as shown on picture? I just want to be sure. Thank you
-
It isn't charger. I've tried 2 different and same thing happens. I also have diy dna 200 and this doesn't happen with any charger
-
I've noticed that the display constantly lights on and off while mod is on charger. Does anybody knows what could be the problem? Mod is Hcigar VT200
-
You do that...
Meanwhile, 4 hours and some 100 puffs later...
-
I'll sold it to you :-D
It came with firmware updated and Wh pre-set to 14.43 Wh,nothing else
If you have some other battery,try with that. I'm sure that is the battery pack problem. Turnigy nano-tech 1000 mAh lasts approximately like this VT200's -
VT200 after 7 hours and 208 puffs at 60W and 0.3 ohm
-
That's gonna be hard,but I will try to do that. There is no rule when it's going to happen. But thank you!
-
It says "0"
-
Well,I managed to broke locking tab on the ZIF socket eventhough I've treated it gently. What can I do now? Can I somehow replace ZIF socket and if yes,where to buy in EU that kind of socket? Thank you
-
Couple of times during the day happens that I got a dead screen. During the dead screen,dna is firing normally. After approximately 20 seconds, it shows evolv dna 200 welcome screen just like I've powered it for first time. It's not a ribbon cable... Any idea?
-
My problem is resolved with setting Watt-hour. One more to go :-)
-
Well,I haven't set that also. It was 8 Wh by default. Now I have used escribe calculator and set it to 11.1 Wh. We'll see today what happens. Thank you
-
Hello to everybody. I have assembled a box with Turnigy Nano Tech 1000mAh battery. I'm using it for 3 days for now and all I have done is firmware update through Escribe and set battery level on main screen. I have noticed that when battery comes to approximately 38% and after 20 mins of not touching mod,battery level shows 59%. This happened for second time and both times at 38% and indicating 59% after a while.
Does anybody else have this problem? Is it a battery or firmware bug?
Picture taken at 10.23AM
Picture taken at 11:40AM
-
Thank you! :-)
-
Sorry if being off topic, but can you please tell me cut-out dimensions for display? In milimeters, please :-)
Let's See your DNA 60's!
in Modders' Forum
Posted
Well,as clean as possible. Only need to isolate up/down wires