[Vt200 battery gone weird]

Any ideas where would I find the CSV file for the TURNIGY NANO-TECH LIPO BATTERY 3S 1300mAh 11.1V 25~50C please

[Vt200 battery gone weird]

Jaquith said:

I think I just replied to you, download your Battery Profile and look at the CSV file. Full 100% should be 4.2V and empty 0% around 3.1V. If you run the Device Monitor look and compare Cell 1, 2 and 3 they should be the same or within ~0.1-0.2V while charging. If it's much more than you have a LiPo that's out if balance. Here are some user tested numbers that I'd use over the Evolv's defaults. HCigar does not properly setup their Mods and uses IMO cheap inferior LiPo's. Settings: Wh = 11.09 Battery Profile (CSV) http://www.filedropper.com/hcigarvt200battery Cutoff (V) = 3.09

Uploaded this to my VT200 it is now showing a pack charge of 10.8v with each cell at 3.6v but charging at 0.001 amps. Normally this device charges to a pack voltage of 12.6v with all cell showing 4.2v. The device itself is showing 5% charged.

I have set escribe to "Perform USB Recovery Charging" and now the device has jumped to 100% charged with a pack voltage of 10.8v. If I fire the device with a 0.7ohm @40Watts it immediately goes to weak battery.

Any ideas Please

UPDATE.... Have ordered a TURNIGY NANO-TECH LIPO BATTERY 3S 1300mAh 11.1V 25~50C XT60, so hopefully this will sort the issue, however does anyone have the required profile for this battery for use in Escribe.