[After update 1.2 Sp3 device shows over Amp charging on vtbox200]

dwcraig1 said:

What battery did you get? I replaced mine with a 1300 mah ( https://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=59112 ) had to shorten the main wires and change the plug. Turned out the original battery was good, got juice on the JST causing #3 cell to slowly drain when idle.

I did order Fullymax with 900 mAh.

[After update 1.2 Sp3 device shows over Amp charging on vtbox200]

I don't know what i'm gonna do now till new battery arrive and test it again.

[After update 1.2 Sp3 device shows over Amp charging on vtbox200]

dwcraig1 said:

On any non Vapor Shark 200 maximum amperage should be 0.5 amp with data path (computer) and 1 amp stand alone charger regardless of their respected output. The DNA 200 board controls charging. 
I'm curious if it's reading the correct amperage but suspect that it is.
Edit: but then again most (not all, eg. USB 3.0) computers only will output 0.5 amps.

my laptop has both USB 3.0 and USB 2.0  and i connect on USB 2.0.
i'm also tried connect with lavabox DNA200 on same USB port and and it doesn't read over 1 A.

and No,there is no juice around the USB.

[After update 1.2 Sp3 device shows over Amp charging on vtbox200]

VapingBad said:

Are you using a VaporShark DNA 200, if so that would be fine as they have 2 A charging, otherwise I would open a support ticket with Evolv.

Thanks for reply

im using vtbox200 V3 
i don't know it would be find or not. I tried using an iPhone wall charger which is 5V 1A the device still shows over 1A like 1.7-1.8A 
its impossible that iPhone wall charger can charge over maximum.

[After update 1.2 Sp3 device shows over Amp charging on vtbox200]

i connect the box on my laptop and it shows USB current about 1.9 A then i tried using 5 V,1 A wall charger and again the device still shows over 1 A i don't know this is a bug or not and i hope it was just a bug on 1.2 SP3  
now i ordered a new battery to try again soon 

i tried downgrade to recommend version of EScribe and still same

what should i do ?