[DNA 75 will not go to 'sleep' - Any ideas?]

Hi Olef, I went through the same process as yours but I'm still experiencing problems with the mod not going to sleep mode. On the screen tab of escribe, is the brightness when charging on your mod set to "0" or a higher value? My problem is instead of the mod going to hibernate/sleep mode it goes to charging mode after firing, if I set the charging brightness to "0", yes the backlight will turn of after being idle but I know it is still in charging mode because if I leave it for a few hours and fire it, it does not show the welcome logo that you get when the device wakes up from sleep mode instead it goes directly to the main screen. Any thoughts? Thanks

[DNA 75 will not go to 'sleep' - Any ideas?]

Olef said:

Hi all

Just got the Vapedroid C1D2 DNA75 last week. I downloaded the Vapedroid config from their Facebook page and applied it.

My C1D2 then started to behave erratically, with the screen turning itself off and on at random and at other times never going off.

So yesterday I downloaded and installed the current recommended Escribe 2016-05-02, and then hard reset the C1D2 and saved the Escribe default config back to it, wiping all of the customisations. I then reset all of my materials profiles etc manually and did not go anywhere near the Vapedroid configs. I did manually set the mod/thermal/case properties as per the Vapedroid settings though.

The C1D2 immediately started to behave as a proper DNA75 (I have a couple of others so know what to expect) and it no longer behaves erratically. I can only conclude at this moment that there is something out of place in the Vapedroid config that causes the strange behaviour.

Hope that helps,

[DNA 75 will not go to 'sleep' - Any ideas?]

helloimage said:

Sorry about that, I'll try to clarify.  Honestly, since I got it working I've been too scared to go back in to escribe with it, hahaha.

#3.  I actually mean 'physically' close the laptop screen. This begins sleep process on my laptop and shuts off peripheral power.

#4. Yes, see #3, the laptop is in standby, although I left the OS running and the escribe application window up.

#6. I assume it's in charge mode because the display layout changes to the charge mode settings. e.g. Tempurature-Sensing Coils -> 'Charging' -> show Ohms, Temperature, Battery Charge %.

whichever pull-down values I select for that mode show up after active->idle->timeout where is should have slept instead.

#9. That would be true, but again, my laptop is powered down.  There must be some data short the mod recognizes on the unpowered yet tethered cable.

Thanks!

 

Hi, I have the same issue with my vapedroid as well, I tried the procedure that you posted, it worked and went to sleep but when I removed the USB the charging screen went on again and if I plug the USB it will go to sleep again. My question is, with your mod did it worked as it should be after removing the USB? THANKS